Use your garbage disposal with the cold water running so that you can preserve the blades of the disposal. Using hot water makes grease more liquid and can cause problems, including clogs. Make sure to clean blades by putting in a little dish detergent and run cold water at the same time.

Taking preemptive action to fix a strange smelling kitchen sink can be a good way to keep your kitchen smelling great. Make sure not to throw hair or grease into your sink. Use baking soda if you have a strange smell coming from your drain. Make sure you use your garbage disposal if you have one to grind up any food and use water while doing this to prevent damage to the blades of the garbage disposal.

Think about what plumbing work you need, then schedule them all at once. By doing so, you can save up enough money to pay for the repairs. You can save money by only paying a single service call fee instead of ending up with multiple hours being billed from multiple visits.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

In gas hot water systems , sometimes the pipes in the plumbing system freeze. You can thaw them out without calling a plumber. Before beginning this process, open the faucet and begin thawing closest to the faucet and then move down the line as sections thaw out. One method you can use is to wrap the pipe with a heavy towel or burlap and then pour hot water over it, set a bucket underneath to catch the water.

If you have problems with a slow drain, there are easier things you can do other than removing the pipes to clean it. There are certain tools made just for this purpose that you insert into the drain to loosen the clog so it washes away or grab it and remove it completely.

When you wash your hands, be sure that you have not left any soap on the faucet handles. What people do not know is that leaving soap on these fixtures can cause fixtures to corrode. Just take two seconds after you are done washing your hands to remove excess soap from the handles.

Believe it or not, it is not a very good idea to use a plunger if your toilet is clogged. Plungers just push whatever is stuck deeper into the drain. Instead, it is a better idea to use a closet auger. It will do a better job and is affordable.

Every now and then, you should pour a large bucket of water down your basement floor drain. This will help to keep the trap seal full and prevent certain gases from coming up into your home. Also, be sure that you have your floor drain checked by a professional every few years.

Do a routine check around your house each month on each and every faucet to make sure there are no signs of leaks or drips. Over time, leaks can add a lot of money to your water bill and will worsen if you do not take care of the problem.

Yes, plumbing is quite a subject in that it is completely subjective by it’s very definition. No two people view plumbing the exact same way. What one finds useful to their system, the other may not. These tips should have given you some advice on how to start with your own plumbing.