Home plumbing is a modern convenience! Indoor plumbing means you do not have to live by a creek or use an outhouse. However, keeping this luxury functioning – where and how you want – without drowning everyone in your home can be an interesting challenge! Read on for some advice on controlling the flow of water in your home.

You always want to solder correctly, the biggest mistake most people make when soldering is failing to get the interior of the fitting and the exterior of the pipe clean and shiny. Polish these surfaces with a fine emery clot until bright. When soldering, never heat the pipe, but instead heat the fitting. Doing so allows the solder to be drawn into the fitting by capillary action.

Solder with safety in mind. When you solder a copper pipe you want to direct the flame on the copper pipe. The flame of the torch has to be four inches away from the piping. The flame should be targeted directly at the point where the copper piping needs to be disconnected.

When starting a plumbing project that is due to loud noises in your pipes empty the pipes first. This can be an easy fix to an other wise wasted huge job. Just close the main water line and open the facets throughout the house. After the water has stopped flowing turn the water on from the main source and check to see if the noise is eliminated.

Do not put cooking oils, fat, or grease, down your drain. These fats cause clogs by solidifying in pipes. To properly dispose of fats, put them in a bowl with a lid that you can dispose of. Once it gets hard, throw it in the trash or compost bin.

Avoid septic tank problems by having your tank pumped out in five year intervals. Having your septic pumped will keep sediments from settling to the bottom of the septic tank and causing the tank to malfunction or backup. Pumping a septic tank might cost a lot of money, but it will cost your more money to clean any back up in sewage you may have had, and replacing your septic tank costs even more!!

Use a hairdryer to thaw frozen pipes, after you shut off the water to the house. A hairdryer will gently heat the pipe and thaw the ice without causing significant damage to the pipe. Shutting off the water first means that if the pipe is broken, there will be no rush of water into the house.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

While it may seem like a seemingly harmless thing to do, never run potato peels through your garbage disposal. The chemical make up of this seemingly harmless food allows the potato to turn into a thick, viscous substance that can wreak havoc on the disposal itself, with the potential to render it completely useless.

To avoid sediment buildup, drain gallons of water from your water heater to flush any corrosion. This will help your heater to run more efficiently therefore saving you regular energy costs. Make sure to read your heater’s instructions before attempting this, and do this periodically to make sure that your heater is running as well as it can.

With a little bit of plumbing, you can route water anywhere you want in your home. Doing so, makes it possible to live anywhere and adds convenience to any room – but done wrong can mean a financial disaster! Keep the wisdom of this article in mind and you can keep the water flowing where you want but in ways you can handle.