One of the major challenges facing the practical application of forward osmosis (FO) membranes is the need for high performance. Thus, the fabrication of highly permselective FO membranes is of great importance. The objective of this study was to improve the wettability/hydrophilicity of electrospun nanofiber (ESNF)-based substrates for the fabrication of nanofiber-supported thin film composite (NTFC) membranes for FO application. This study explored the impact of electrospun polyethersulfone/polyacrylonitrile (PES/PAN) nanofibers as the blend support to produce NTFC membranes. The blending of PES/PAN in the spinning dope was optimized. The blending of hydrophilic PAN (0-10 wt%) in PES affects the fiber diameter, hydrophilicity, water uptake, and roughness of the ESNF membrane substrates. Continuous thermal-rolling pretreatment was performed on the ESNF substrates prior to interfacial polymerization for polyamide active layer deposition. The results indicated that the fabricated NTFC membrane achieved significantly greater water flux (L/m2 h) while retaining a low specific salt flux (g/L) compared to traditional TFC membranes. The NTFC membrane flux increased with an increase in PAN content in the ESNF substrate. According to the FO performance results, the NTFC-10 (PES/PAN blend ratio of 9010) exhibited optimal performance a high water flux of 42.1 and 52.2 L/m2 h for the FO and PRO modes, respectively, and low specific salt flux of 0.27 and 0.24 g/L for the FO and PRO modes, respectively, using 1 M NaCl as the draw solution. This demonstrated the higher selectivity and water flux achieved by the developed NTFC membranes compared to the traditional TFC membranes.In this study, graphene oxide and titanium dioxide in combination with sodium alginate were used to synthesize the reduced graphene oxide-TiO2/sodium alginate (RGOT/SA) aerogel. The potential of RGOT/SA aerogel was evaluated for the photocatalytic degradation of ibuprofen and sulfamethoxazole and was compared with that of bare titanium dioxide nanoparticles. More than 99% removal of both the contaminants was obtained within 45-90 min by using the RGOT/SA aerogel under UV-A light. Mineralization of both the pollutants was also higher in case of RGOT/SA aerogel as compared to bare TiO2 nanoparticles. The optimal mass ratio of TiO2 nanoparticles with respect to graphene oxide was 21 in RGOT/SA aerogel in the presence of 1 wt% sodium alginate solution. High photodegradation of Ibuprofen was observed at neutral pH and acidic to neutral pH was found suitable for the photodegradation of sulfamethoxazole. Three-dimensional interconnected macroporous assembly, large surface area for settling TiO2 nanoparticles, efficient charge partitioning, and enhanced physical and chemical adsorption of ibuprofen and sulfamethoxazole on the surface of RGOT/SA aerogel were the significant characteristics of RGOT/SA aerogels. Moreover, ease of separation and recyclability of the RGOT/SA aerogel could further save the extra energy used to separate nanoparticles from the effluent.A novel p(AA)-g-GO material was prepared by grafting polymerization of acrylic acid (AA) onto graphene oxide (GO) skeleton, presenting efficient removal of dyes from wastewater, because the layer spacing of GO is expanded and successfully introduced numerous polar carboxyl groups. The study revealed a rapid adsorption kinetic process and the adsorption capacity for methylene blue (MB) increases with pH, contact time, initial dye concentration and temperature. The maximum adsorption capacity is about 1448.2 mg/g at 25 °C for MB according to the Langmuir isotherm. HS94 supplier More importantly, the adsorbent maintains excellent adsorption capacity after five cycles of adsorption-desorption and has remarkable selective separability for methylene blue/methyl orange mixed solution at pH = 10. Furthermore, the equilibrium adsorption capacities for other cationic dyes as malachite green (MG), basic fuchsin (BF) and rhodamine B (RhB) reached 582.1, 571.7 and 437.1 mg/g, respectively. Additionally, the mechanism analysis indicated that electrostatic interactions, π-π conjugation and hydrogen bonding are the predominant forces for adsorbing cationic dyes. Therefore, p(AA)-g-GO is an outstanding adsorbent and has a potential application prospect in the treatment of dye wastewater.Mining activities lead to important physical, chemical and biological effects on soil properties, generating severe impacts in the establishment and maintenance of vegetation. Assisted phytoremediation can be considered an environmentally friendly approach for soil remediation. In this study, two mining soils (PORT and GAM) were treated with 10%, by mass, of the following amendments manure biochars prepared at 450 °C (BMW450) and 600 °C (BMW600), hydrochars prepared by hydrothermal carbonization (HTC) of manure at 190 °C (HWM190) and 240 °C (HMW240) and manure waste (MW). Brassica napus was used as a phytoextraction species. After 45 days of plant growth, soil samples were widely characterized, including microbial biomass carbon, enzymatic activity and metal content. In addition, plant biomass production, bioconcentration factor, translocation factor and metal uptake were determined. Experimental results showed that addition of biochars improved the As uptake by Brassica napus in both soils but just in the roots increasing bioconcentration factor between 22.1 and 39.5% for GAM soil and between 28.6 and 53.4% for PORT soil. Brassica napus cannot be considered as Zn accumulator in GAM soil samples and in the case of PORT samples, only the addition of BMW600 and HMW240 enhanced the phytoextraction process of Zn on the roots. Soil enzyme activity improved in hydrochar amended soils.Residual veterinary antibiotics have been detected in livestock wastewater treatment plants. Despite the long retention time, antibiotic treatment efficiency has shown clear limitations. In this study, we evaluated submerged membrane photobioreactors (SMPBR) during sulfonamide antibiotic-containing livestock wastewater treatment under mixotrophic and photoautotrophic conditions. The results showed that microalgal sulfur degradation and consumption under mixotrophic conditions accelerated the biomass concentration increase to 2800 mg VSS/L compared to the 1800 mg VSS/L measured under photoautotrophic conditions. Although microalgal metabolites, such as soluble microbial products and extracellular polymeric substances, might cause membrane fouling in the SMPBR, we proved that microalgae could remove sulfonamide and release degradation-associated sulfur, along with nitrogen and phosphorus. Moreover, this study confirms the statistical correlation between metabolites and sulfonamides. In summary, the results of this study provide promising insights into antibiotic-containing livestock wastewater treatment.